Cooper Security 9751 Podręcznik Użytkownika Pobierz pdf (Strona 32)

4. Programming

Page 30 496929

X3 Double Knock (2) Zones with this attribute will cause an alarm

condition only if one or more sensors generate two alarms events

within a five minute time window, or if one zone remains open for

more than 10 seconds. Programming a zone as ‘Double Knock’ is a

way of reducing false alarms caused by environmental changes, but is

not normally recommended.

Note: ‘Double Knock’ is available only for Normal Alarm and Entry Route

zone types.

X4 Omit Allow (O) When applied to a zone, this attribute allows the user

to omit the zone.

B Level B When applied, the zone will be armed when the user selects

Level B.

C Level C When applied, the zone will be armed when the user selects

Level C.

D Level D When applied, the zone will be armed when the user selects

Level D.

X7 Sensitivity When you use this Command you must also enter an extra

digit in the range 1 to 6 in order to set the sensitivity of the shock

sensor. 1 is least sensitive, 6 is most sensitive. Note that to use this

attribute you must make one of zones 1 to 4 a shock analyser type.

To adjust the sensitivity you must enter the complete Command, for

example to change the sensitivity to 3 you must key in: X7 + 3.

20: Change Engineer Code

To change the Engineer access code:

1. Make sure you are in programming mode.

2. Key in 20 and press Y.

The display shows:

20:Code

3. Key in a new four digit Engineer access code.

The display shows:

20:Code ****

4. Press Y.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 55 56

Brak uwag

Cooper Security 9751 Podręcznik Użytkownika Strona 32