Cooper Security i-on160EX Podręcznik Użytkownika Pobierz pdf (Strona 35)

i-on160 3. Setting and Unsetting

Page 29

Note: The radio keypad does not show the status of the alarm

system at all. The left hand “Transmit” LED glows only to

show that the keypad is sending a command to the control

unit.

Using a Remote Control

Setting

Note: You must ask your Administrator to provide a suitably

programmed remote control, see i-on40 Administrator’s Guide.

Secure all your windows and doors.

Make sure the system is idle, and that you can hear the warning

tones from the sounders.

1. Press the appropriate button on the remote control, either

full set (A) or part set (B) (see Figure 7).

Figure 7. Remote Control Button Functions.

The keypad sounds the exit warning tone.

2. Leave by the exit door and make sure it is closed properly (if

you have not already done so).

At the end of the exit time the exit tone stops you should

hear a double “beep” confirmation tone. The keypad display

shows the message “System Set” for a few seconds. The

installer may also have programmed your external

sounder/strobe to flash briefly, and one of the keypad LEDs

to glow to indicate which part of the system is set.

Not used

ransmit LED

Full Set

Part Set

Unset

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 103 104

Brak uwag

Cooper Security i-on160EX Podręcznik Użytkownika Strona 35