Cooper Security i-on 16 Przewodnik Instalacji Pobierz pdf (Strona 15)

i-on40

Page 11

Note: Connecting the battery without mains

power will not start the system. (See

“Programming A Control Unit Before

Installation” below if you wish to start the

system on battery power.)

Programming Before Installation

If you prefer, you can make the control unit

learn the detectors and other peripherals

before installing the system in its final

location. You will need to temporarily

connect a keypad to the end station.

It is possible to operate the end station

from battery power (or a 12Vdc supply)

without connecting the unit to a mains

supply. However, in order to start the end

station processor running you must briefly

short the Kick Start pins together after

connecting the battery.

When programming the system while it is

running on battery only, remember to leave

the Installer Menu before removing power.

If you do not do so all your changes will be

lost, see Important! Saving Changes on

page 13

If you wish to program the control unit

from a laptop or PC you can do this by

connecting the control unit to your PC via

Ethernet. You will need a CAT 5 patch cable

and a laptop or PC with a standard web

browser. See the separate publication i-

on40 Web Server Set Up Guide for

instructions on how to set up your

PC/laptop and the control unit.

Step 8. Initial Power-Up

WARNING: During initial power-up all the

keypad sounders and any internal

loudspeaker will give an alarm tone. If you

are working at the top of a ladder make

sure that the sudden noise does not startle

you and cause a fall.

1. Apply mains power to the control unit.

The keypads and internal sounder give

an alarm tone. The heartbeat LED (see

fig 3 ) starts flashing.

The display initially shows:

Language?

English

2. Press u or n to show other languages

on the bottom line of the display. for

example:

Language?

Nederlands

3. Press Y to select the language you

want.

From this point on, the display operates

in the selected language. If you want to

change the language later use Installer

Menu - System Options - Language.

The display shows:

COUNTRY DEFAULTS

*UK

4. Press u or n to show other countries,

for example:

COUNTRY DEFAULTS

Italy

5. Press Y to select the country you want.

The display shows:

A : Partition mode

B : Part set mode

6. Press A or B to select either a

partitioned system or a Part Setting

system.

The display shows:

Load Profile?

7. Either: Press Y to load the Profile.

Or: Press

X to start with a blank

system

The end station loads your choice of

profile, and then shows:

WIRED ZONE TYPE

*2-wire FSL 2k2/4k7

8. Press u or n to show the range of

wiring types available, for example:

WIRED ZONE TYPE

4-wire CC

9. Press Y to select the wiring type you

intend to use for the wired zones

The display shows:

I-ON40

00:00 01/01/2009

Note that the alert LEDs round the

navigation glow red. This is because the

end station lid is off and the tamper is

active.

10. Remove both battery and mains power.

Re-apply battery power followed by

mains.

The sounders stop.

At this point you can carry on to

commission the system. See the next page.

Note: Setting the time and date is an

administrative user function. See i-on40

Administrator’s Guide for instructions.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag