Cooper Security i-on40 Przewodnik Instalacji Pobierz pdf (Strona 32)

Installer Mode Programming i-on40

Page 28

To teach the control unit the WAM’s identity:

1 Select Detectors/Devices – WAM – Add/Del WAM.

The bottom line of the display shows the first of two

available “memory slots” for learning WAM modules.

Each memory slot can hold the identity of a single

WAM module. When a slot is occupied with a WAM

then the bottom line shows a “*” at the beginning.

2. Press u or n to select the memory slot that you wish

to use, followed by Y.

The display asks you to activate the tamper switch on

the WAM.

3. Activate the WAM tamper.

The WAM signals its identity to the i-on40 control

unit. When the control unit learns the WAM’s identity

the keypad gives a double beep.

Viewing a WAM

To check the functions of the WAMs currently learned by

the control unit:

1. Select Detectors/Devices – WAM – View WAM.

The bottom line of the display shows the first in a list

of the available WAM memory slots. When a slot is

occupied with a WAM then the bottom line shows a

“*” at the beginning.

2. Press u or n to select the WAM whose function you

wish to view.

The bottom line of the display shows one of the

following:

Repeater Module.

Output Module.

Sounder Module.

Not Used.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 115 116

Brak uwag

Cooper Security i-on40 Przewodnik Instalacji Strona 32