Cooper Security M-Series Instrukcja Obsługi Pobierz pdf (Strona 46)

4. Programming

40 496478

adjust the sensitivity you must enter the complete com-

mand, for example to change the sensitivity to 3 you must

key in: X7 + 3.

Change Engineer Code (Command 20)

To change the Engineer access code:

1. Make sure you are in programming mode.

2. Key in 20 and press Y.

The display shows: 20:Code

3. Key in a new four digit Engineer access code.

The display shows: 20:Code ****

4. Press Y.

Loudspeaker Chime (Command 22)

A user may find that the chime tone from the keypads is not loud enough. If

so, then use command 22 option 1 to make the internal sounder also give the

chime tone. To alter the volume of the tone from the internal sounder enter a

digit in the range 1 to 9. 1 is quietest, 9 is loudest. The keypad demonstrates

the volume of the tone when you enter the digit.

RedCare Reset (Command 23)

Option 1 enables RedCare Reset, which is designed to operate with the plug-

by communicator, or remote PC reset.

Note: You must set System Reset to Engineer (Command 33 option 1) to ensure

RedCare Reset works correctly.

After an alarm the user keys in their access code to silence the alarm, but

cannot reset the system. The first to alarm and Service LEDs remain lit. The

user contacts the central station, who verify the user's identity. The central

station can send a signal back to the control unit. The Service LED goes dark

and the the end user can now reset the system with any valid access code,

providing that there are no faults.

Use option 0 (the default) to disable the function.

Continuous Sounder (Command 25)

Option 0 of this command makes the internal sounder follow the external bell

delay and duration times. Option 1 makes the internal sounder continue after

the external bell times out.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 70 71

Brak uwag

Cooper Security M-Series Instrukcja Obsługi Strona 46