Cooper Security 9751 Podręcznik Użytkownika Pobierz pdf (Strona 14)

14 496661

3. After an Alarm

When your system raises an alarm you must disarm it in order to switch off

the sounders and strobes. The system keeps a record of which zone(s)

triggered the alarms, and shows the zone number(s) on the keypad display.

Once you have disarmed the system, you must reset the system before you

can start using it again.

Fire Alarm

The system gives a fire alarm by sounding a warbling tone from the keypads

and alarm sounder. The keypad display shows the letters " ".

1. Evacuate the premises and call the Fire Brigade. Do not attempt to unset

the alarm.

2. When the premises are safe, follow the instructions below.

Disarming the System

If you have a 725r telecommand and the system is part set then press .

The system gives a double "beep" to show that it is unset.

Go to step 3.

If the system is full set then:

1. Go to the keypad via the entry route.

2. Key in your access code.

The sounders go quiet and the

system gives a double "beep" to

show that it is unset. The keypad

display shows alarm and the zone

number of the first detector to be

triggered. You may also see the

lamp glowing.

3. Establish the cause of the alarm.

4. Carry on to reset the system.

Resetting the System

There are three different methods for resetting. You can tell which method

your system uses by looking at the lamp after an alarm.

• If the lamp is dark then the system uses Customer Reset. You can

reset the system yourself from the keypad.

• If the lamp glows after an alarm then your system uses Engineer

Reset. Call your alarm company and ask for an engineer to visit the

premises to reset the system.

"beep beep"

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Brak uwag

Cooper Security 9751 Podręcznik Użytkownika Strona 14