Cooper Security i-on 16 Instrukcja Instalacji Pobierz pdf (Strona 10)

Page 10 of 16

3.14 I-ON Panel Configurations

Now configure the panel using the guide below and with the correct information supplied

for the site installations.

5 = Communication

1 = ARC Reporting

1 = Call Mode

2 = IP Network

1 = Unit Name - Enter in the account number for the monitoring centre.

2 = Polling IP Address - Set this to the IP address of the monitoring centre in a

12 digit format e.g. 80.176.196.135 = 080176196135.

3 = ARC IP Address

1 = IP Address 1 - Set this to the IP address of the monitoring Ccentre in a

12 digit format e.g. 80.176.196.135 = 080176196135.

2 = IP Address 2 - Please leave blank as the IRIS Touch will download the

backup address from the monitoring station.

3 = Account Number

1 = Account No P1 - Enter in the account number for the monitoring centre,

this must be the same as the unit name.

4 = Report Type - Set to the alarm format requested by the monitoring

mentre or mustomer e.g. Fast Format, Contact ID,

SIA (1-2), SC SIA 3 or Ex SIA 3.

5 = CID/SIA Events - Ensure that the relevent Alarm Events you wish to send are enabled.

4 = IP Network (own)

1 = Module: Ethernet

1 = IP Address - Program in the IP address for the IRIS Touch 600 range

e.g. 192.168.0.10

2 = Port Number - Enter the TCP/IP port number for Upload/Download

connection.

3 = Subnet Mask - Enter the subnet mask i.e. 255.255.255.240

4 = Gateway Address - Enter the network gateway IP address

e.g. 192.168.001.00

Please note that if you make changes to the account number and ARC IP address these will

not be sent down to the IRIS Touch until an alarm is sent from the panel. Once the alarm is

sent the new configuration will be configured into the IRIS Touch.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Brak uwag

Cooper Security i-on 16 Instrukcja Instalacji Strona 10