Cooper Security i-on 16 Instrukcja Instalacji Pobierz pdf (Strona 12)

Page 12 of 16

3. Select “Installers Menu” and enter the default installer code “111111” and

press “OK”.

 Note: On the IRIS Touch welcome screen you have some letters and

GSM signal Stength shown on the top line, these are indications of the

following:

E = Ethernet Synchronisation.

S = Serial communication (RS232).

Poll = Communication (polling) to the monitoring Centre.

Ѱ = Shows you have GSM registration and Signal Strength.

8. Select the “Test” option from the Installation Menu.

9. The IRIS Touch will now go check the physical Ethernet is plugged in.

If this reports back disconnected then please check the cable and connections

at both ends.

10. The IRIS Touch will now check a valid IP address has been entered.

If “IP address OK” then press “continue”, if not then please confirm the IP

settings within the panel.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Brak uwag

Cooper Security i-on 16 Instrukcja Instalacji Strona 12