Cooper Security i-on160EX Przewodnik Instalacji Pobierz pdf (Strona 114)

Step by Step Programming Procedures i-on160

Page 108

Assigning Wired and Radio Expanders to Partitions

1. Enter Installer Menu.

INSTALLER MENU

Detectors/Devices >

2. Press Y.

DETECTORS/DEVICES

Detectors >

3. Press n until the display shows EITHER (if you

are adding a wired expander):

OR (if you are adding a radio expander):

DETECTORS/DEVICES

Wired Expanders >

DETECTORS/DEVICES

Radio Expanders >

4. Press Y .

(The rest of these instructions assume you are

naming a wired expander. The same instructions

will also work for a radio expander.)

WIRED EXPANDERS

Address Bus Device >

5. Press n until the display shows:

WIRED EXPANDERS

Edit Expander >

6. Press Y .

EDIT EXPANDER

Exp. W1-01 (W10)>

7. Press u or n to select the expander that you

wish to name. Then press Y.

The bottom line of the display shows the option

“Name”.

Exp. W1-01

Name >

8. Press n until the display shows:

Exp. W1-01

Partitions >

9. Press Y .

Exp. W1-03

Partition 01 Yes

10. To allocate an expander to a Partition press > or

< until the end of the bottom line shows “Yes”.

To remove an expander from a Partition press >

or < until the end of the bottom line shows

“No”. You can allocate and expander to more

than one Partition. See page 52 for more

information about partitions.

Exp. W1-03

Partition 1 No

To allocate (or remove) an expander to or from

all Partitions in one go:

Press u or n until the bottom line of the display

shows “All Partitions”.

Press > or < until the end of the bottom line

shows “Yes” or “No” as required.

Exp. W1-03

All Partitions No

11. Press n to show other partitions.

Exp. W1-01

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 179 180

Komentarze do niniejszej Instrukcji

Brak uwag

Cooper Security i-on160EX Przewodnik Instalacji Strona 114

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Cooper Security i-on160EX