Cooper Security i-on160EX Przewodnik Instalacji Pobierz pdf (Strona 17)

i-on160 Basic Programming Procedures

Page 11

Defaulting Access Codes

If the User and/or Installer codes are lost then you can set the installer and

Master User codes to their default and delete all the other users, including their

tags, remote controls and PAs.

1. If possible, enter the Installer menu.

INSTALLER MENU

Detectors/Devices >

Note: If you cannot enter Installer Menu then the

control unit will start a tamper alarm when you

open its lid.

2. Remove mains power, then open the control

unit and disconnect all batteries.

Note: This procedure will not work if the control

unit lid tamper remains closed.

3. Identify the Reset Codes pins on the main PCB

(see i-on160EX Installation Guide).

4. Short the Reset Codes pins together using a

small screwdriver or jumper link. (Keep the

short on until step 6.)

5. Apply mains power.

The control unit loads the factory default

access codes:

Grade 2: User 01=1234, Installer=7890.

Grade 3: User 01=123456, Installer=567890.

The control unit starts a tamper alarm. After a

pause of several seconds (during which the

keypad display shows first the software

revision of the keypad and then the words

“Please wait...”) the keypad display shows the

time and date.

The red LEDs glow to show an alert that the

control unit lid is open.

6. Remove the short from the Reset pins.

7. Reconnect the batteries.

8. Close the control unit lid (to restore the

tamper switch).

The display shows the time and date, for

example:

I-ON160EX

00:00 01/11/2010

9. Key in the default User 01 code to silence the

sounders.

The display shows:

Call Installer

Panel lid open

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 179 180

Komentarze do niniejszej Instrukcji

Brak uwag

Cooper Security i-on160EX Przewodnik Instalacji Strona 17

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Cooper Security i-on160EX