Cooper Security i-on160EX Przewodnik Instalacji Pobierz pdf (Strona 61)

i-on160 Installer Menu Options

Page 55

before the system sets. This may be needed if detectors are being set off

by air movements caused by the final door being closed. During this

period, the sounders stop and the system sets but the control unit ignores

any alarms generated by the detectors.

Enter two digits to specify a time in seconds, from 01 to 30.

Note: This option is available for Final Door Set exit mode only.

Exit Time

The exit time can take any value between 10s and 120s.

Note: If you select Final Door Set or Instant Set for the exit mode then the Exit

Time option does not appear in the menu.

Entry Time

The entry time can take any value between 10s and 120s. The entry time

you select in this option applies to Full set and all Part Sets.

Strobe on Set (Part Set Strobe Set)

When set to ON this option causes the control unit to activate any output

programmed as Strobe, plus the strobe on any 760ES wireless siren. The

outputs/strobes are active for three seconds after the system sets. Strobe

On Set applies to Full Set and all the Part Sets.

Strobe on Unset (Part Set Strobe on Set)

When set to ON this option causes the control unit to activate any output

programmed as Strobe, plus the strobe on any 760ES wireless siren. The

outputs/strobes are active for three seconds after the system unsets.

Strobe On Unset applies to Full Set and all the Part Sets.

Alarm Response/Part Set Alarm Response

You can select one of the following:

Internal: Keypads and loudspeakers.

Siren Keypads, loudspeakers and siren.

Siren + Comms Keypads, loudspeakers, siren and

communication. Note that any Siren

Delay (see page 69) applies to

“Siren+Comms”, but not “Internal” or

“Siren” alarm responses.

Part Set Final Exit As

This option controls how the system will treat Final Exit zones in a part

set.

Final Door In a Part Setting system, any Final Exit zones

with the Part Set B, C or D attributes will

continue to act as Final Exit zones during part

set.

In a Partitioned system, any Final Exit zones,

belonging to the partition, with the Part Set

attribute will continue to act as Final Exit

zones during part set.

Normal Alarm In a Part Setting System any Final Exit zones

with the Part Set B, C or D attributes will act

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 179 180

Komentarze do niniejszej Instrukcji

Brak uwag

Cooper Security i-on160EX Przewodnik Instalacji Strona 61

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Cooper Security i-on160EX