i-on40 & i-onEX Range 1. Introduction
Page 11
In Security Grade 2 the Master User‟s default access code is
“1234”; in Security Grade 3 it is “123456”. By default the master
User does not have any tag or other device registered to their
account.
Cooper Security Limited recommend that you change the
default access code as soon as possible (see page 42).
Codes 0000 (or 000000) to 9999 (or 999999) are available but
Cooper Security Limited recommends that you avoid easily
memorised codes such a 0000, 999999 or 654321.
The installer has their own access code which they cannot use to
set or unset the alarm system. Neither can they use that code to
change details of other users registered to the system. Similarly,
the Master User code has no access to any installer programming
menus and cannot be used to edit the Installer code.
Proximity Tags
A proximity tag is a small plastic token with a low powered radio
transmitter inside. Each tag contains a unique identity code.
(There are 4,294,967,296 (2
32
) different tag identity codes.)
Inside the keypad is a sensor. When you present the tag within
about 10mm of the front of the keypad, the control unit senses
the presence of the tag and reads its identity code.
If a user presents a tag that the control unit recognises then the
control unit allows the user to access the system in the same way
as if they had keyed in a recognised access code.
Code Lockout
If a user has problems remembering their code, or has acquired
an unrecognised tag, they may try keying in their code or
presenting the tag several times. If this happens 10 times in a
row then the control unit locks all keypads for 90 seconds. Once
the 90 seconds is finished then the keypads will allow users to try
once again. If the user gets it wrong again then the keypad will
lock them out for a further 90s. Note that the system will log the
fact that someone has locked the keypads in this way by
recording “Excess keys”.
Komentarze do niniejszej Instrukcji