Cooper Security i-on160EX Instrukcja Użytkownika Pobierz pdf (Strona 24)

2 Alarms i-on40 & i-onEX Range

Page 18

The number displayed on the bottom line is a special code

(“4321” is just an example). Note this code down, you will need it

when you talk to the alarm company.

Press  to clear the message and the display returns to normal.

The LEDs around the navigation keys remain red. Call your alarm

company and tell them that an alarm has occurred.

When you talk to the alarm company, they will ask about the

circumstances of the alarm, and also for the code you recorded

from the display. If the alarm company decides that an engineer

does not need to visit you, then they will give you another four

digit code (the “anti-code”).

Key in the anti-code at the keypad. The system will reset, and

you can carry on using it as before.

Accidental Alarms

Your Installer may have programmed your alarm system so that

if you set off an alarm accidentally then you have a short time

(usually 90 seconds) to cancel the alarm. Go immediately to a

keypad and key in your access code. If you do this within the

time limit then the alarm system will send an “Alarm Abort”

message to the alarm receiving centre.

If your system is partitioned, then you can only cancel alarms for

the partitions you belong to. A “partition user” must also use a

keypad allocated to the partition in alarm.

Ask your Installer how much time they have programmed to allow

you to cancel an alarm.

Speech Messages

Note: This facility requires fitting a communications module to

your alarm system, ask your installer for more details.

As well as making an audible signal, the installer can program the

control unit to send pre-recorded voice messages over the

telephone network. These messages can go to a person

nominated to monitor alarm calls.

Each message has two parts: a Home section that identifies your

system, and an alarm section that gives the nature of the alarm.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 121 122

Brak uwag

Cooper Security i-on160EX Instrukcja Użytkownika Strona 24