
1. Introduction i-on40 & i-onEX Range
Page 14
Figure 5. HUA Buttons
HUA With A Two-Way Key Fob
It is possible to start a Hold Up Alarm from a two-way key fob.
However, the Installer must enable this within the control unit.
(Note that doing so will mean that the system no longer complies
with BS8243 or DD243.)
Once the Installer has enabled this feature, a Master User must
also turn this facility on, see page 106.
When the feature is fully enabled, to start a HUA from a Fob-2W-
4B:
Press and hold any two
diagonally opposite buttons at
the same time.
All four LEDs flash red three
times.
The control unit starts a hold
up alarm. If your system is
connected to an alarm
receiving centre the control
unit sends a hold up alarm
message to them. The control
unit then sends a message to
the fob to confirm that it has
started a hold up alarm.
All four LEDs glow green for
three seconds.
Komentarze do niniejszej Instrukcji