Cooper Security i-on 16 Podręcznik Użytkownika Pobierz pdf (Strona 23)

i-on30EX

Page 19

Figure 30 Fitting the ADSL01 Filter.

Note: If you remove the ADSL01 filter then

re-fit the jumpers to the outermost pairs of

pins. If you fail to re-fit the jumpers the

internal communicator will not connect to

the phone line.

Step 9. Fit a Plug-By

Communicator

The control unit can be connected to a

separate communicator or speech dialler

(for example, the Scantronic 8400, 8440,

660 or RedCare STU). Figure 31 shows the

connections provided by the

communications wiring harness. Note that

the output types shown in Figure 31 are the

Factory default types. See the i-on Range

Engineering Guide for details on how to

change the defaults.

Figure 31 Plug-By Communicator Wiring

Note: Comms O/P4 will be active when the

system is unset. This is normal.

To fit a communicator, follow the

instructions below.

Caution: Follow the instructions in the order

shown, or you may damage the

control unit and/or communicator.

1. Disconnect mains power from the

control unit, remove the case lid, and

disconnect the battery (if the system

has already been installed).

2. Make any necessary connections from

the communicator to the communication

wiring harness. The default is a 12V

positive voltage when the output is

inactive.

Refer to the next section if you are

using a dual-path communicator.

3. Plug the Communication Wiring Harness

onto the communications connector on

the main PCB.

If the system has already been installed:

4. Re-connect the battery.

5. Fit the case lid.

6. Apply mains power.

7. Test communicator operation.

Note: You will need to speak to the ARC in

order to confirm that the communicator has

worked correctly.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Komentarze do niniejszej Instrukcji

Brak uwag