Cooper Security 9751 Instrukcja Instalacji Pobierz pdf (Strona 51)

3. Installation

496964 Page 43

Comms O/P1 (Brown) -ve applied (+ve removed) in alarm

Comms O/P2 (Orange) -ve applied (+ve removed) in alarm

Comms O/P3 (Yellow) -ve applied (+ve removed) in alarm

Comms O/P4 (Green) -ve applied (+ve removed) in alarm

Comms O/P5 (Blue) -ve applied (+ve removed) in alarm

Comms O/P6 (Purple) -ve applied (+ve removed) in alarm

Comms O/P7 (White) -ve applied (+ve removed) in alarm

Comms O/P8 (Grey) -ve applied (+ve removed) in alarm

Line Fail input (White/Brown) +12V applied to indicate telephone line fail.

Tell Back input (White/Orange) +12V appied to change from engineer to customer reset.

0V (Black)

12V (Red)

Com Connector Cable, Part No. 485210

Figure 32. Communications Wiring Harness

4. Plug the Communication Wiring Harness onto the communications

connector on the main PCB (see Figure 5).

5. On the 9751, re-fit the PCB to the support pillars. Secure the PCB to the

support pillars with the screws provided (Figure 33). Make sure that the

bottom left corner of the PCB is seated on its support pillar.

Figure 33. Fitting Control Unit PCB (9751)

If the system has already been installed:

6. Re-connect the battery.

7. Fit the case lid.

8. Apply mains power.

9. Test communicator operation (using Commands 151 to 158).

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 147 148

Brak uwag

Cooper Security 9751 Instrukcja Instalacji Strona 51