Cooper Security M2000 Podręcznik Użytkownika Pobierz pdf (Strona 16)

Introduction Engineering Manual

Two programmable outputs (one switched positive and one switched negative).

Connection for up to four keypads.

Support for one loudspeaker.

MRNode

By fitting one or more MRNodes to a system the installer can employ a variety of wirefree

detectors to protect areas without running extra cabling. In addition, the user gains the ability to

set and unset the system using radio telecommands, or start panic alarms using PA transmitters.

The MRNode connects to the control unit over the standard network cabling. The control unit

treats the wire free detectors as standard zones. Each MRNode can support up to eight

detectors, plus any combination of telecommands or PA up to a maximum of eight devices.

MSPSU

The MSPSU has an on-board power supply, which provides power for devices connected to the

MSPSU, or for other devices on the network. The MSPSU also enables the system to be

expanded by an extra eight zones and one programmable output. The zones can connect to

movement detectors, smoke detectors, panic buttons or other sensors. You may also connect

up to four keypads and one extension loudspeaker to the MSPSU.

Note: The MSPSU acts as an MSNode and can replace one of these nodes on the network.

Consequently, each MSPSU added reduces the allowable number of MSNodes by one.

WARNING: This device may contain mains voltages.

CPA6 Output Module

The CPA6 Output Module (now obsolete) provides eight switched-negative programmable

outputs rated at 100mA, which can be used to drive LEDs or relays, perhaps to give ward status

information and/or zone alarm indications.

See page 2 for details of how many modules can be connected to each control unit.

LEC2

The LEC2 expander provides two zones and one switched-negative output. Note that a LEC2

must not share a network with a Node or MSPSU.

LEC6

(Now obsolete.) Direct connection of an LEC6 (6-zone) expander to a control panel network port

is supported for existing systems that are being upgraded. Ensure that the number of zones

does not exceed the number that could be provided by keypads alone. Note that a LEC6 must

not share a network with a Node or MSPSU.

8600 Relay Card

The 8600 Relay Card allows you to convert the on board digital communicator outputs from

transistor outputs to voltage free relay outputs. Each 8600 provides eight relays. Later M800 and

M2000 pcbs provide connectors for the cables supplied with the 8600.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 179 180

Brak uwag

Cooper Security M2000 Podręcznik Użytkownika Strona 16