Cooper Security M2000 Podręcznik Użytkownika Pobierz pdf (Strona 38)

Engineer Menu 1-1 Engineering Manual

Beam Pair

Zones with this attribute cause an alarm only if two or more zones that are in the same

ward and have the Beam Pair attribute trigger within the time specified by the Beam Pair

timer (page 64). This attribute is normally used only for areas protected by an array of

infra-red beams, with each beam connected to a separate zone. Zones that have the Beam

Pair attribute should be the same type (normally Normal Alm or Perimeter).

Monitored

When triggered, a zone with this attribute activates outputs that follow the Monitored O/P

On (page 48) or Monitor (page 55) event.

Non Latching

Select this attribute for a zone of type Keyswitch (page 24), Shunt Key (page 24) or

Security (page 27) if a non-latching switch is used (i.e. a switch where the contacts do not

stay open after the key is operated).

Supervision

This attribute is for use with radio zones. If you wish to enable supervision for a radio zone

then you must set both the supervision warning timer, (option 1-5-2 27, see page 66).

and the supervision failure time (option 1-5-2 28, see page 66) to a figure greater

than 0.

YES – The control unit monitors this zone for supervision (default).

NO – The control unit ignores all supervision problems with this zone.

Note: By default the supervision attribute is set to YES for all zones, including the hardwired

zones. The control unit uses supervision monitoring on radio zones only, not on

hardwired zones.

Activity

This attribute works together with Downloader to aid remote monitoring of individual

zones. When enabled, the control unit sets an internal flag if the zone has been activated

at any time within the last seven unsetting periods. Downloader can display the state of

this flag and a remote engineer can use this information to judge the health of the

detector for that zone. An installer on-site can also view the state of this flag by means of

“View Zones” option 2-1. The display shows an “A” if the zone has been active within

the last seven unset periods.

YES – The control unit monitors this zone for activity.

NO – The control does not monitor this zone for activity (default).

Step 4 – Select Zone's Wards

Each zone can be assigned to one or more wards.

If the Ward configuration option (page 84) is set to ON, Zones assigned to more than one ward

will only be armed when all the wards they are in are set (by default this option is set to OFF).

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 179 180

Brak uwag

Cooper Security M2000 Podręcznik Użytkownika Strona 38